Isolated Current Sense Reference Design (±300 A) for Traction Inverter With Overcurrent Detection(TIDA-01543)

Thisreference design provides detection of traction motor phase currents. The TIDA-01543 design realizes an isolated current sensor solution. Precise in-line huntbased, motor phase current sensing is done with AMC1305M05-Q1 delta-sigma (ΔΣ) modulators and the INA301-Q1 device. The high CMTI of the modulator helps suppress inverter switching transients from corrupting the data on the controller side. The fast response time of the INA301-Q1 enables faster reaction times for overcurrent events. The TIDA-01543 provides an interface to connect to an external MCU where digital SINC filters can be implemented to demodulate the AMC1305M05 output bit stream. This TI Design uses the C2000 family, automotive-qualified F280049M Piccolo™ icrocontroller control card.

Возможности

Reinforced, isolated ΔΣ modulator to measure in-line motor phase current with shunt resistor Short-circuit response time of < 1.5 μs with SINC 3 filter and OSR 8 Nominal phase current measurement range of ±300 A; transient peak range of ±80 Apk with 100-μΩ shunt resistor Calibrated full-scale error of < 0.5 % across temperature range from 0°C to 125°C Short-circuit response time of 300 ns with INA301 (parallel configuration alongside the AMC modulator) High CMTI of modulator (> 15 kV/μs) improves noise immunity to switching transients

Файлы

Схемы и диаграммы

Быстро получите общее представление о схемотехнике решения

Тесты и Инструкции

Протестируйте плату по готовым тестам

Печатные платы и ПО

Ускорьте разработку по готовому дизайну

Спецификация (BOM)

Загрузите полный список требуемых компонентов.

Isolated Current Sense Reference Design (±300 A) for Traction Inverter With Overcurrent Detection TIDA-01543

Сравнение позиций

  • ()