Ваш город: Москва
+7 (495) 221-78-04
+7 (812) 327-327-1
Применения > Тестирование и измерение > Source Generation > AC / DC Power Sources > High-Side V-I Converter, 0-2V to 0-100mA, 1% Full Scale Error

High-Side V-I Converter, 0-2V to 0-100mA, 1% Full Scale Error (TIPD102)

This Verified Design delivers a well-regulated current to a ground-referenced load that could be used for actuators, sensors, motors, and many other applications. The design utilizes a two-stage approach to allow the high-side current source to accept a ground-referenced input. The first stage uses an op amp and n-channel MOSFET to translate the ground-referenced input to a supply-referenced signal. The supply-referenced signal drives the second stage op amp that controls the gate of a p-channel MOSFET to regulate the load current. The OPA2333 is used for both stages of the design because of the low quiescent current, rail-to-rail input/output, and zero-drift chopper technology. The rail-to-rail input stage includes voltages that exceed both supply rails so there is no loss or "dead-zone" when used as a low-side sink for the first stage or as a high-side source for the second stage. The rail-to-rail output ensures that the op amp is able to successfully turn off the active devices ensuring low zero-scale currents. The zero-drift architecture allows for precision DC performance over temperature. See more TI Precision Designs


Converts Voltage to current: 0 to 2 V, 0 mA to 100 mA Less than 0.1 % Error Single-supply solution with rail-to-rail input dual-channel op amp Good compliance voltage to the both rails Design creates a current source that allows for a GND referenced load Excellent DC performance and temperature drift using zero-drift OPA2333 op amp This Verified Design Includes: Theory Component Selection TINA-TI Simulation Schematics and PCB Layout Verification and Measured Performance Modification Options


Схемы и диаграммы

Быстро получите общее представление о схемотехнике решения

Печатные платы и ПО

Ускорьте разработку по готовому дизайну

Спецификация (BOM)

Загрузите полный список требуемых компонентов.

High-Side V-I Converter, 0-2V to 0-100mA, 1% Full Scale Error TIPD102

Возможность заказа

Покупка печатной платы для TIPD102

Цена: 2138 r
от 3 шт. 1010 q
от 5 шт. 816 q
Срок поставки 3 недели

Используемые компоненты

Производитель: Texas Instruments
OPA2333AID OPA2333AID Цена, руб. Срок поставки Укажите

IC, MICROPOWER OP-AMP; Amplifiers, No. of:2; Op Amp Type:Zero Drift; Gain, Bandwidth -3dB:350kHz; Slew Rate:0.16V/чs; Voltage, Supply Min:1.8V; Voltage, Supply Max:5.5V; Termination Type:SMD; Case Style:SOIC; Pins, No.…
208,00 r
от 17 шт. 178,00 q
от 37 шт. 164,00 q
На складе: 768 шт.

Заметили ошибку в работе сайта?
Скажите нам об этом