Терраэлектроника

100/200Vac Input, 30W Isolated Power Supply Reference Design for Servo Drives (TIDA-00315)

This reference design provides isolated 24Vdc, 16Vdc (x3) and 6V outputs to power the control electronics, IGBT module and fan for 100Vac/200Vac input servo drives. The power supply can be either powered directly from a single or 3- phase AC mains or can be powered from the DC link voltage. This reference design uses primary-side regulation, quasi-resonant flyback topology and is rated for 30W output. The line and load regulation of the power supply is designed to be within 5%. The power supply is designed to meet the clearance, creepage and isolation test voltages as per IEC61800-5 requirements

Возможности

30W isolated main power supply for servo drives Can operate with DC Link (450Vdc max) or AC input (200VAC) Load and line Regulation: 5% Input UV/OV, Output overload & SC protection Protection against loss of feedback Lower system cost solution using UCC28711 through primary side regulation, eliminating feedback loop Quasi-Resonant mode controller improves EMI Operating temp range: -10ºC to 65ºC Designed to comply with IEC 61800-5

Файлы

Схемы и диаграммы

Быстро получите общее представление о схемотехнике решения

Печатные платы и ПО

Ускорьте разработку по готовому дизайну

Спецификация (BOM)

Загрузите полный список требуемых компонентов.

100/200Vac Input, 30W Isolated Power Supply Reference Design for Servo Drives TIDA-00315

Заметили ошибку в работе сайта?
Скажите нам об этом