Терраэлектроника
Применения > > Evaluation board with STM32L476ZG MCU

Evaluation board with STM32L476ZG MCU (STM32L476G-EVAL)

The STM32L476G-EVAL evaluation board has been designed as a complete demonstration and development platform for STMicroelectronics ARMВ® CortexВ®-M4 core-based STM32L476ZGT6 microcontroller with three IВІC buses, three SPI, six USART ports, CAN port, SWPMI, two SAI ports, 12-bit ADC, 12-bit DAC, LCD driver, internal 128-Kbyte SRAM and 1-Mbyte Flash memory, Quad-SPI port, touch sensing capability, USB OTG FS port, LCD controller, Flexible Memory Controller (FMC), JTAG debugging support.

The full range of hardware features on the board can be used to evaluate all peripherals (USB OTG FS, USART, digital microphones, ADC and DAC, dot-matrix TFT LCD, LCD glass module, IrDA, LDR, SRAM, NOR Flash memory device, Quad-SPI Flash memory device, microSD card, sigma-delta modulators, smartcard with SWP, CAN transceiver, I²C, EEPROM, RF-EEPROM) and develop user’s applications. Extension headers make it possible to easily connect a daughterboard or wrapping board for a specific application.

An ST-LINK/V2-1 is integrated on the board, as embedded in-circuit debugger and programmer for the STM32 MCU and USB virtual COM port bridge.

Возможности

  • STM32L476ZGT6 microcontroller with 1-Mbyte Flash memory and 128-Kbyte RAM
  • Four power supply options: power jack, ST-LINK/V2-1 USB connector, USB OTG FS connector, daughterboard
  • Microcontroller supply voltage: 3.3 V or range from 1.71 V to 3.6 V
  • Two MEMS digital microphones
  • Two stereo audio headphones jack outputs with independent audio content
  • Slot for microSD card supporting SD, SDHC, SDXC
  • 4-Gbyte microSD card bundled
  • 16-Mbit (1M x 16 bit) SRAM device
  • 128-Mbit (8M x 16 bit) NOR Flash memory device
  • 256-Mbit Quad-SPI Flash memory device with Double Transfer Rate (DTR) support
  • RF-EEPROM with IВІC bus
  • EEPROM supporting 1 MHz IВІC-bus communication speed
  • RS-232 port configurable for communication or STM32L476ZGT6 flashing
  • IrDA transceiver
  • USB OTG FS Micro-AB port
  • CAN 2.0A/B-compliant port
  • Joystick with four-way controller and selector
  • Reset and wake-up / tamper buttons
  • Touch-sensing button
  • Light-dependent resistor (LDR)
  • Potentiometer
  • Coin battery cell for power backup
  • LCD glass module daughterboard (MB979) with 40x8-segment LCD driven directly by STM32L476ZGT6
  • 2.8-inch 320x240 dot-matrix color TFT LCD panel with resistive touchscreen
  • Smartcard connector and SWP support
  • NFC transceiver connector
  • Connector for ADC input and DAC output
  • Power-metering demonstration with dual-channel sigma-delta modulator
  • PT100 thermal sensor with dual-channel sigma-delta modulator
  • STM32L476ZGT6 current consumption measurement circuit
  • Access to comparator and operational amplifier of STM32L476ZGT6
  • Extension connector for motor control module
  • JTAG/SWD, ETM trace debug support, user interface through USB virtual COM port, embedded ST-LINK/V2-1 debug and flashing facility

Файлы

Схемы и диаграммы

Быстро получите общее представление о схемотехнике решения

Печатные платы и ПО

Ускорьте разработку по готовому дизайну

Спецификация (BOM)

Загрузите полный список требуемых компонентов.

Evaluation board with STM32L476ZG MCU STM32L476G-EVAL

Используемые компоненты


Производитель: ST Microelectronics
STM32L476G-EVAL STM32L476G-EVAL Цена, руб. Срок поставки Укажите
кол-во:

Отладочная плата STM32L476G-EVAL на основе микроконтроллера STM32L476ZG. PDF ИНФО
18902,00 r
На складе: 2 шт.
STM32L476ZGT6 STM32L476ZGT6 Цена, руб. Срок поставки Укажите
кол-во:

ARM Microcontrollers - MCU Ultra-low-power with FPU ARM Cortex-M4 MCU 80 MHz with 1 Mbyte Flash, LCD, USB OTG PDF ИНФО
1024,00 r
от 2 шт. 896,00 q
от 5 шт. 768,00 q
от 10 шт. 705,00 q
На складе: 29 шт.

Заметили ошибку в работе сайта?
Скажите нам об этом