Терраэлектроника
Применения > > Motor control evaluation and development kit for the ST7MC. Includes firmware, GUI, ST7MC samples, a 12VDC-240VAC 1000W inverter

Motor control evaluation and development kit for the ST7MC. Includes firmware, GUI, ST7MC samples, a 12VDC-240VAC 1000W inverter (ST7MC-KIT/BLDC)

The Softec motor control starter kit for ST7MC (ST ordering code: ST7MC-KIT/BLDC) is an integrated system designed to provide you with a complete, ready-to-use motor control application for the ST7MC family of microcontrollers. It allows real-time control of three-phase brushless DC and AC motors in all control topologies from a PC-based GUI, or in standalone operation.

The control panel software provides an easy-to-use interface to configure, start and run the motor, modify parameters and evaluate ST7FMC motor control features, then generate header files for your own motor control application.

The kit also comes with the STXF-INDART/USB in-circuit debugger/programmer and STVD7 integrated development environment that allow you to take advantage of the ST7FMC’s on-chip resources for in-circuit programming and in-circuit debugging.

For further information about the motor control starter kit, please refer to www.st.com/mcu, or the Softec internet site www.softecmicro.com.

For more information about inDART in-circuit debuggers/programmers, please refer to the ST7xxxx-INDART Data Brief.

Возможности

  • Motor control board
    • Motor and board input power stage
    • Optoisolation board
    • Auxiliary power supply and voltage rectification
    • Push buttons, trimmers for standalone operation
    • Hall sensor input
    • Three-phase outputs to motor
    • Tachometer input for closed-loop controlled AC motors
    • 10-pin ICC connector for in-circuit programming and in-circuit debugging
    • Prototyping area
    • RS-232 connector
  • Control panel software
    • Parameter configuration for BLDC and 3-phase induction motors
    • Basic settings interface for configuring motor, start-up and real time parameters
    • Advanced settings interface for configuring frequency, speed range, stop conditions, etc.
    • Outputs header files for your application taking into account modifications to the configuration
  • STXF-INDART/USB
    • 10-pin ICC connection
    • USB connection to host PC
    • Two breakpoints
    • Advanced breakpoints on data, access type, access range, stack.

Файлы


Заметили ошибку в работе сайта?
Скажите нам об этом