Применения > > RN1810 Wi-Fi PICtail/PICtail Plus Daughter Board

RN1810 Wi-Fi PICtail/PICtail Plus Daughter Board (RN-1810-PICtail)

Based on Microchip's new low power IEEE 802.11b/g/n Wi-Fi module the RN1810, the RN1810 PICtail™/ PICtail Plus Daughter Board allows customers to easily develop Wi-Fi applications using Microchip’s 8, 16 and 32-bit PIC® microcontrollers. The kit includes a fully integrated TCP/IP stack allowing for a simple serial to Wi-Fi connection to the microcontroller. The board features a USB interface for easy plug-and-play development with a PC. The board is also compatible with the Explorer 16 Development Board (DM240001), PICDEM.net2 Development Board (DM163024) and PIC32 Starter Kit (DM320001) with I/O Expansion Board (DM320002).


    • Enables rapid development with the RN1810 low power 802.11b/g/n Wi-Fi module
    • PICtail™ and PICtail Plus interfaces for connection to Microchip Explorer 16 (DM240001) , PIC32 I/O Expansion board (DM320002) or PIC18 Explorer (DM183032) development boards
    • On-board USB to UART bridge for easy development from PC
    • On-board connection and data status LEDs
    Module Features:

    • IEEE 802.11b/g/n Compliant Transceiver
    • 2.4 GHz IEEE 802.11n Single Stream 1x1
    • UART Interface to Host Controller (4-wire including RTS/CTS)
    • Configured using Simple ASCII Commands
    • Supports Infrastructure and SoftAp Networking Modes
    • Built-In Networking Applications: IPv4/IPv6, TCP, UDP, DHCP, DNS, ICMP, ARP, HTTP, FTP, SNTP, and SSL/TLS
    • Complete On-Board TCP/IP Networking
    • Upgrade Firmware Over the Air using TFTP
    • Supports Wi-Fi® Protected Setup (WPS)
    • Modular Certified for the United States (FCC), Canada (IC), Europe, Australia, New Zealand, Korea, Taiwan, and Japan


Тесты и симуляция

Протестируйте плату по готовым тестам

RN1810 Wi-Fi PICtail/PICtail Plus Daughter Board RN-1810-PICtail

Заметили ошибку в работе сайта?
Скажите нам об этом