Ваш город: Москва
+7 (495) 221-78-04
+7 (812) 327-327-1
Терраэлектроника
Применения > > MIC2125YML-20A Eval Board

MIC2125YML-20A Eval Board (MIC2125YML-20A-EV)

The MIC2125/6 Demo Board has been developed to demonstrate the capabilities ofthe MIC2125/6 device with two adaptive ON-time control architectures:

  • Hyper Speed Control (MIC2126)
  • HyperLight Load (MIC2125)
The MIC2125 and MIC2126 Evaluation Boards require only a single power supply withat least 10A current capability. The MIC2125/6 each have an internal VDD LDO, so noexternal linear regulator is required to power the internal biasing of the IC. Inapplications with VIN < +5.5V, VDD should be tied to VIN to by-pass the internal linearregulator. The output load can either be a passive or an active load.
The MIC2125/6 Evaluation Boards do not have reverse polarity protection. Applying anegative voltage to the VIN and GND terminals may damage the device. The maximumVIN of the board is rated at 28V.

Возможности

    • Hyper Speed Control® Architecture Enables:
    High delta V operation (VIN = 28V and VOUT = 0.6V)

    • Any Capacitor™ stable
    • 4.5V to 28V Input Voltage
    • Adjustable Output Voltage from 0.6V to 24V
    • 200 kHz to 750 kHz Programmable Switching Frequency
    • HyperLight Load® (MIC2125)
    • Hyper Speed Control (MIC2126)
    • Enable Input and Power Good Output
    • Built-in 5V Regulator for Single-Supply Operation
    • Programmable Current Limit and “Hiccup” Mode Short-Circuit Protection
    • 7 ms Internal Soft-Start, Internal Compensation, and Thermal Shutdown
    • Supports Safe Start-Up into a Prebiased Output
    • –40°C to +125°C Junction Temperature Range
    • 16-pin, 3 mm × 3 mm QFN Package

Файлы

Печатные платы и ПО

Ускорьте разработку по готовому дизайну

Спецификация (BOM)

Загрузите полный список требуемых компонентов.

MIC2125YML-20A Eval Board MIC2125YML-20A-EV

Заметили ошибку в работе сайта?
Скажите нам об этом