Применения > > KSZ9031RNX EVAL BOARD


The KSZ9031RNX is a completely integrated triple speed (10Base-T/100Base-TX/1000Base-T) Ethernet Physical Layer Transceiver for transmission and reception of data over standard CAT-5 unshielded twisted pair (UTP) cable. The KSZ9031RNX reduces board cost and simplifies board layout by using on-chip termination resistors for the four differential pairs and by integrating a LDO controller to drive a low cost MOSFET to supply the 1.2V core. On the copper media interface, the KSZ9031RNX can automatically detect and correct for differential pair misplacements and polarity reversals, and correct propagation delays and re-sync timing between the four differential pairs, as specified in the IEEE 802.3 standard for 1000Base-T operation. The KSZ9031RNX provides the Reduced Gigabit Media Independent Interface (RGMII) for direct connection to RGMII MACs in Gigabit Ethernet Processors and Switches for data transfer at 10/100/1000 Mbps speed. The KSZ9031RNX Evaluation Board (KSZ9031RNX-EVAL) provides a comprehensive platform to evaluate the KSZ9031RNX features. All KSZ9031RNX configuration pins are accessible either by jumpers, test points or interface connectors.


    • KSZ9031RNX 10Base-T/100Base-TX/1000Base-T Physical Layer Transceiver • RJ-45 Jack for Ethernet cable interface • Auto MDI/MDI-X for automatic detection and correction for straight-through and crossover cables • RGMII Loopback for standalone evaluation • LED Indicators for link status and activity • Jumpers to configure strapping pins • Manual Reset Button for quick reboot after re-configuration of strapping pins • USB port for MDC/MDIO programming access to KSZ9031RNX PHY registers


Тесты и симуляция

Протестируйте плату по готовым тестам

Спецификация (BOM)

Загрузите полный список требуемых компонентов.

Заметили ошибку в работе сайта?
Скажите нам об этом