Ваш город: Москва
+7 (495) 221-78-04
+7 (812) 327-327-1
Применения > > VND5T035AK Evaluation Board

VND5T035AK Evaluation Board (EV-VND5T035AK)

EV-VND5T035AK provides you an easy way to connect ST’s surface mounted VIPower®drivers into your existing prototype circuitry. This evaluation board comes pre-assembled with VND5T035AK-E high-side driver.

The VND5T035AK-E is monolithic device made using STMicroelectronicsВ®VIPower technology, intended for driving resistive or inductive loads with one side connected to ground. Active VCCpin voltage clamp protects the device against low energy spikes.

The device integrates an analog current sense which delivers a current proportional to the load current.

Fault conditions such as overload, overtemperature or short to VCCare reported via the current sense pin. Output current limitation protects the device in overload conditions. The device latches off in case of overload or thermal shutdown.

The device is reset by a low level pass on the fault reset standby pin.

A permanent low level on the inputs and on the fault reset standby pins disables all outputs and sets the device in standby mode.


  • Simple single IC application board dedicated for VND5T035AK-E
  • Provides thermal heat-sinking for ease of use in prototyping
  • Provides electrical connectivity for easy prototyping


Заметили ошибку в работе сайта?
Скажите нам об этом