Терраэлектроника
Применения > > MCP1710 Demo Board

MCP1710 Demo Board (ADM00468)

The MCP1710 Demo Board demonstrates how the MCP1710 device operates over a wide input voltage and load range. Test points are provided for input and output, allowing the demo board to be connected directly to a system. A copper via connected to the EN input can be used to turn the MCP1710 on and off. Turning the device on, (EN > 70% of VIN) will enable the device. When the EN pin is less than 30% of VIN, the device output is turned off.

Devices Supported: MCP1710

Возможности

  • Output Voltage set to 3.0V
  • 200 mA Output Current
  • EN Input Test Point
  • Input Voltage Range 2.5V to 5.5V
  • Ultra Low Quiescent Current of 20 nA
  • Low-Dropout Voltage: 450 mV Maximum at 200 mA

Файлы

Тесты и симуляция

Протестируйте плату по готовым тестам

MCP1710 Demo Board ADM00468

Заметили ошибку в работе сайта?
Скажите нам об этом