Ваш город: Москва
+7 (495) 221-78-04
+7 (812) 327-327-1
Применения > > MCP19111 Evaluation Board

MCP19111 Evaluation Board (ADM00397)

The MCP19111 is a digitally-enhanced PWM controller. It combines a pure-analog PWM controller with a supervisory microcontroller making it a fast, cost-effective, and configurable power conversion solution. The MCP19111 is ideal for standard power conversion, LED drivers, and battery charging applications. The MCP19111 Evaluation Board demonstrates how the MCP19111 device operates in a synchronous buck topology over a wide input voltage and load range. Nearly all operational and control system parameters are programmable by utilizing the integrated PIC microcontroller core. MPLAB X IDE can be used in conjunction with a Graphical User Interface (GUI) plug-in to easily configure the MCP19111. Alternatively, the user can program the MCP19111 using their own firmware, tailoring it to their application. The evaluation board contains headers for ICSP™ (In-Circuit Serial Programming™) as well as I2C communication, pull-up and pull-down resistor pads and test point pads on each GPIO pin, and two push buttons for system development.

Devices Supported: MCP19111

PLEASE NOTE: This kit does NOT contain the hardware programming tool. Please use Microchip’s PICKIT3 (PG164130).


    • Vinrange: 5V to 12V
    • Adjustable Voutrange: 0.5V to 3.6V
    • Maximum output current: 30A with proper air flow
    • Programming and I2C communication headers
    • Factory programmed to produce 1.8V from 12V source
    • The factory programmed source code is available


Схемы и диаграммы

Быстро получите общее представление о схемотехнике решения

Спецификация (BOM)

Загрузите полный список требуемых компонентов.

MCP19111 Evaluation Board ADM00397

Заметили ошибку в работе сайта?
Скажите нам об этом