USB Host Shield (SparkFun Electronics)

Наименование USB Host Shield
Производитель SparkFun Electronics(SPARKFUN)
Артикул 819592

SparkFun USB Host Shield The SparkFun USB Host Shield contains all of the digital logic and analog circuitry necessary to implement a full-speed USB peripheral/host controller with your Arduino. This means you could use your Arduino to interface with and control any USB slave device - thumbdrives, digital cameras, bluetooth dongles, and much more! A four-wire serial interface is used to communicate with the host controller chip, so the shield connects the Arduino's hardware SPI pins (D10-13) to the MAX3421E. A USB type A female connector is wired up to the IC, and it also supplies 5V as any normal USB port would. The Host Shield takes its power from the Vin' pin on your Arduino. Power from that pin is regulated to both 5V and 3.3V on the shield. All SPI signals are sent through a hex converter to step them down to 3.3V.

USB Host Shield 2.0 for Arduino (WZE)
от 1170,00 Склад (1-2 дн)

USB Host Shield 2.0 for Arduino This is revision 2.0 of USB Host Shield. Thanks to new interface layout it is now compatible with more Arduinos - not only UNO and Duemilanove, but also big Mega and Mega 2560 work with Standard variant of this shield out of the box.…

USB Host Shield 2.0 for Arduino (WZE)
от 1170,00 Склад (1-2 дн)

USB Host Shield 2.0 for Arduino This is revision 2.0 of USB Host Shield. Thanks to new interface layout it is now compatible with more Arduinos - not only UNO and Duemilanove, but also big Mega and Mega 2560 work with Standard variant of this shield out of the box.…