Analog Distance Sensor 10-150cm. 5V (Pololu Robotics and Electronics)

Наименование Analog Distance Sensor 10-150cm. 5V
Производитель Pololu Robotics and Electronics(POLOLU)
Артикул 1871574

Pololu Carrier with Sharp GP2Y0A60SZLF Analog Distance Sensor 10-150cm, 5V The GP2Y0A60SZ distance sensor from Sharp offers a wide detection range of 4 to 60 (10 cm to 150 cm) and a high update rate of 60 Hz. The distance is indicated by an analog voltage, so only a single analog input is required to interface with the module. The sensor ships installed on our compact carrier board, which makes it easy to integrate this great sensor into your project, and is configured for 5V mode. Sharp's distance sensors are a popular choice for many projects that require accurate distance measurements. This particular sensor is small and affordable, making it an attractive alternative to sonar rangefinders, while its wide sensing range and resistance to interference from ambient IR set it apart from other IR distance sensors. It consists of a Sharp GP2Y0A60SZLF module installed on our compact carrier board, which includes all of the external components required to make it work and provides a 0.1 pin spacing that is compatible with standard connectors, solderless breadboards, and perfboards. With an ability to measure distances from as close as four inches to as far as five feet (10 cm to 150 cm), this sensor has the widest range of any of our Sharp distance sensors, and its 60 Hz update rate is more than twice that of Sharp's older GP2Y0A02YK0F analog distance sensor that has a similar sensing range. Interfacing to most microcontrollers is straightforward: the single analog output, OUT, can be connected to an analog-to-digital converter for taking distance measurements, or the output can be connected to a comparator for threshold detection. The sensor automatically updates the output approximately every 16 ms. The enable pin, EN, can be driven low to disable the IR emitter and put the sensor into a low-current stand-by mode. This pin is pulled high on the carrier board through a 10 k? pull-up resistor to enable the sensor by default. A 1?4 strip of 0.1 header pins and a 1?4 strip of 0.1 right-angle header pins are included, as shown in the picture below. You can solder the header strip of your choice to the board for use with custom cables or solderless breadboards, or you can solder wires directly to the board itself for more compact installations. The board features one 0.125 mounting hole that works with #4 or M3 screws (not included); if you do not need the mounting hole, you can cut that part of the board off to reduce its size. Operating voltage: - 5V version: 2.7V to 5.5V - 3V version: 2.7V to 3.6V - Average current consumption: 33 mA (typical) - Distance measuring range: 10 cm to 150 cm (4 to 60) - Output type: analog voltage - Output voltage differential over distance range: - 5V version: 3.0V (typical) - 3V version: 1.6V (typical) - Update period: 16.5 ± 4 ms - Enable pin can optionally be used to disable the emitter and save power - Size without header pins: 33 mm ? 10.4 mm ? 10.2 mm - Weight without header pins: 2.5g

ZX Distance and Gesture Sensor (SPARKFUN)
от 1260,00 Склад (1-2 дн)

ZX Distance and Gesture Sensor The ZX Distance and Gesture Sensor is a touchless sensor that is capable of looking for simple gestures. Developed in conjunction with XYZ Interactive, the sensor uses their GestureSense® technology to recognize the distance of an object away from the sensor up to about 10 inches (~25cm) and the location of the object from side to side across the sensor in about a 6 inch (~15cm) span.…

Расчет доставки...