Каталог решений

forward

Высокоскоростной USB Тип C

Описание:
PMP11114 is a dual port USB Type C Charger. This design takes an automotive input voltage (7V to 18V nominal, load dump to 40V). The output goes to two USB Type ports, each of these ports supplies 5V. The desgin supports 3A on one port and 1.5A on the other port. The DC/DC portion of the design is rated for 5A total current. The design is fully compliant with USB type C and backwards compliant with BC1.2 and DCP configurations.

Возможности:

USB Type C compliant Efficiency is greater than 90% after USB switches Max component temp is 55C with full load Compact board size (50mm x 55mm) Power path sharing to limit port current

Возможность заказа
  • Заказать BOM
Документация:
  • Схемотехника
  • BOM
Описание:
The PMP11124 reference design uses the UCC28700 and TPS25810 to provide an isolated 5V at 3A over a USB type C interface. The UCC28700 implements primary-side regulation, eliminating the need for an opto-coupler and reducing the size and cost of the design. Cost is further minimized by using an output diode instead of a synchronous rectifier.

Возможности:

USB type C interface Minimal component count provides low cost solution 3A capability advertisement on CC line Meets class B conducted EMI limits

Возможность заказа
  • Заказать BOM
Документация:
  • Схемотехника
  • BOM
Описание:
This is a power bank reference design with a USB typc C DFP plus a USB type A port supporting high voltage discharging. Fast charger input is also supported to save more charging time. It can detect the input port attach/detach automatically, as well as the output ports.

Возможности:

Type C DFP Enabled @5V/3A Fast Charger input supported Fast Discharging with high voltage output Automatic Attach/Detach Detection High Discharging Current High Integration and Low BOM

Возможность заказа
  • Заказать BOM
Документация:
  • Схемотехника
  • BOM
Описание:
The PMP4488 is low cost 5V3A car charger reference design providing Type C DFP feature and is compliant with BC1.2 device. The design includes a non-synchronous step-down regulator TPS54340 and highly integrated USB type-C controller TPS25810. The PMP4488 demonstrates high efficiency, good line/load regulation and thermal performance.

Возможности:

7~40Vin wide input range USB-C DFP only+BC1.2 Non-SR solution with 2layer design reduces cost 89% @ 12Vin full load with good thermal performance Size: 43mm x 20mm x 5.6mm

Возможность заказа
  • Заказать BOM
Документация:
  • Схемотехника
  • BOM
Описание:
This addapter converts a USB standard host type-A port to Type-C DFP (downstream-facing port) with support for default, 1.5 A and 3.0A VBUS current levels. The TUSB2522 simplifies the design by integrating 2:1 USB 3.1 (up to 10 Gbps) mux with a DFP controller to monitor the Type-C configuration channel (CC) pins to determine plug orientation for mux selection and device attachment for controlling VCONN and VBUS power switches.

Возможности:

Plug and Play design The Reference Design operates off of the 5-V VBUS input from the legacy Type A USB connection The Reference Design can provide VCONN over a CC pin based upon Type C plug orientation and Ra detection DIP switch is provided to configure CC for different Type C current mode operations

Документация:
  • Схемотехника
  • BOM
  • Тестирование